Rite-ride 4174 Manuel d'utilisateur télécharger pdf

RECOMMENDED O PERATING P RESSURES

Van 5 - 35 p.s.i.

23-8373 10-10 NAD-29686-1

DESCRIPTION QTY.

AIR SPRING 2

PLUG 1

LOWER PROTECTOR 2

UPPER PROTECTOR 2

18' AIR LINE 1

NYLON TIE 6

INFLATION VALVE 2

5/16" FLAT WASHER 4

PARTS LIST

Read installation instructions in its entirety before installing your Coil-Rite Kit

4174

STEP 1 - VEHICLE PREPARATION

Remove the positive battery cable. With the vehicle on

a solid level surface chock the front wheels. Raise the rear

wheels of the vehicle using a lift or platform jack rated for

your vehicle weight. Lower the vehicle frame onto jack

stands rated for your vehicle's weight making sure the

suspension is fully extended. (DO NOT use wood or

concrete blocks to support the weight of the vehicle.)

STEP 2 - AIR SPRING PREPARATION

Cut a section of air line tubing 3 inches in length and

insert into the push-to-connect air inlet on the air spring

(a "saw" cut with a sharp knife is preferred). Exhaust the

air from the air spring by rolling it up toward the air inlet.

After the air is exhausted, install the plug into the tubing

coming out of the air spring see Figure "A".

STEP 3 - INSTALL PROTECTOR

Place the lower protector in the bottom of the coil

spring. Install the upper protector onto the stud inside the

coil spring. See Figures "B", "C", & "D".

STEP 4 - INSTALL THE AIR SPRING

Insert the bottom of the flattened air spring into the coil

spring through the lowest opening in the coil spring with

the push-to-connect air inlet at the bottom of the coil

spring see Figure "D".

WARNING

Do not inflate this assembly when it is

unrestricted. The assembly must be restricted by

a coil spring. Do not inflate beyond recommended

operating pressures for your specific vehicle.

Improper use or over inflation may cause property

damage or severe personal injury.

FOR BEST RIDE use only enough air

pressure in the air helper springs to level the

vehicle when viewed from the side (front to

rear). This amount will vary depending on the

load, location of load, condition of existing

suspension and personal preference.

FIGURE "A"

FIGURE "B"

PLUG

AIR LINE

COIL-RITE

AIR SPRING

COIL SPRING

LOWER PROTECTOR

www.riderite.com

1 2 3 4

Résumé du contenu

Page 1 - AIR SPRING

RECOMMENDED O PERATING P RESSURESVan 5 - 35 p.s.i.23-8373 10-10 NAD-29686-1DESCRIPTION QTY.AIR SPRING 2PLUG 1LOWER PROTECTOR 2UPPER P

Page 2 - UPPER SUPPORT

FIGURE "D" FIGURE "E" FIGURE "F"AIRINLETLOWERPROTECTORAIR LINEPUSH-TO-CONNECTINFLATION VALVEFLAT WASHERHEX NUTVALVE

Page 3 - Do Not Return This Product

Do Not Return This Product to the Dealer or DistributorIf you are• missingparts,• experiencinginstallationproblems,or• havetechnicalconcerns

Page 4

FIRESTONE LIMITED LIFETIME AIR SPRING WARRANTYFirestone Industrial Products Company LLC (“Firestone”) warrants that its Ride Rite Air Spring Assembly

Commentaires sur ces manuels

Pas de commentaire

Rite-ride 4174 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Rite-ride 4174. Rite-Ride 4174 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Rite-ride 4174