Rite-ride 2100 Manuel d'utilisateur télécharger pdf

2100

21-8155 12-03 NCD-5984-1

INSTALLATION INSTRUCTIONS

Congratulations - your new Air Helper Springs are

quality products capable of improving the handling and

comfort of your vehicle. As with all products, proper

installation is the key to obtaining all of the benefits your

kit is capable of delivering. Please take a few minutes to

read through the instructions to identify the components

and learn where and how they are used. It is a good idea to

start by comparing the parts in your kit with the parts list

below.

The heart of the air helper spring kit is, of course, the air

helper springs. Remember that the air helper springs must

flex and expand during operation, so be sure that there is

enough clearance to do so without rubbing against any

other part of the vehicle.

Be sure to take all applicable safety precautions during

the installation of the kit. The instructions listed in this

brochure and the illustrations all show the left, or driver’s

side of the vehicle. To install the right side assembly simply

follow the same procedures.

Your kit includes separate inflation valves and air lines

for each air helper spring. This will allow you to level your

vehicle from side to side as well as from front to back. If

you would rather have a single valve inflation system, your

dealer can supply the required "T" fitting.

IMPORTANT!

For your safety and to prevent possible damage to your

vehicle, do not exceed the maximum load recommended by

the vehicle manufacturer (GVWR). Although your Air

Helper Springs are rated at a maximum inflation pressure

of 100 P.S.I., this pressure may allow you to carry too great

a load on some vehicles. Check your vehicle owner’s

manual for maximum loads listed for your vehicle.

When inflating your Air Helper Springs, add air

pressure in small quantities, checking pressure frequently

during inflation. The air spring requires much less air

volume than a tire and, therefore, inflates much quicker.

WARNING:

Do not inflate this assembly when it is

unrestricted. The assembly must be restricted by

the suspension or other adequate structure. Do

not inflate beyond 100 P.S.I. Improper use or

over inflation may cause property damage or

severe personal injury.

267C AIR SPRING 6781 2

UPPER BRACKETS 5162 2

LOWER BRACKETS 5163 2

BRACKET STRAP 5086 2

AIR LINE TUBING 1

3/8"-16 FLANGE LOCK NUT 16

3/8"-16 X 3/4" FLANGE HEX BOLT 2

3/8"-16 x 4-1/2" CARRIAGE BOLTS 4

3/8" SPECIAL WASHER 8

3/8"-16 X 1 1/2 HEX BOLTS 8

5/16" FLAT WASHER 4

PUSH TO CONNECT

INFLATION VALVE 2

PUSH TO CONNECT

ELBOW FITTING 2

THERMAL SLEEVE 2

NYLON TIE 6

PARTS LIST

Installation of this kit requires a

minimum of 7-1/2"

of clearance between the tire side wall

and the frame.

Fits 1973-1991 Suburban 4x2's and 4x4's

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

210021-8155 12-03 NCD-5984-1INSTALLATION INSTRUCTIONSCongratulations - your new Air Helper Springs arequality products cap

Page 2

6TROUBLE SHOOTING GUIDEAir spring will not inflateEnsure that the air line tubing is inserted into the air fittings as far as possible. The tubing s

Page 3

7FIRESTONE LIMITED LIFETIME AIR SPRING WARRANTYFirestone Industrial Products Company LLC (“Firestone”) warrants that its Ride Rite Air Spring Assembly

Page 4 - STEP 8 - CHECK THE AIR SYSTEM

Page 5 - Operating Instructions and

267C

Page 6

FRONTFRONT FIGURE B FIGURE "C" FIGURE "D" FIGURE "E"STEP 1 - PREPARE THE VEHICLEWith the vehicle on a solid, level s

Page 7

NOTE: Once the air helper springs are installed, it is recommended that the vehicle not be lifted by the frame, as over-extension may occur, r

Page 8 - ONLINE AUCTION PURCHASES

Operating Instructions and Trouble Shooting Guide21-1083 4-12 Thank you for purchasing Firestone air helper springs. You have purchased a quality prod

Page 9 - AIR SPRING TECHNICAL DATA

2SAFETY TIPSNever exceed the manufacturer’s recommended Gross Vehicle Weight Rating (GVWR)As with your vehicle’s tires, an air helper spring is a pneu

Page 10 - IMPORTANT

3the suspension system. As more air pressure is added to the air springs, they will support more weight. You will be able to compensate for a heavy lo

Page 11 - WARRANTY QUESTIONS

4INFLATING THE AIR SPRINGSWith the air helper springs installed on your vehicle and the vehicle sitting on a level surface, visually verify that the v

Page 12 - STEP #3:

5Description Style Ride Height“X”Min/Max AirPressureMax Load @100 psi(per pair)6868 Single Convoluted 160BY 5.0" - 6.0" 5 / 100 psi 3600 lbs

Commentaires sur ces manuels

Pas de commentaire

Rite-ride 2100 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Rite-ride 2100. Rite-Ride 2100 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Rite-ride 2100