Rite-ride 1003 Manuel d'utilisateur télécharger pdf

1003

Level-Rite

Congratulations— your new Air Helper Springs are quality

products capable of improving the handling and comfort

of your vehicle. As with all products, proper installation is

the key to obtaining all of the beneﬁts your kit is capable

of delivering. Please take a few minutes to read through

the instructions to identify the components and learn

where and how they are used. It is a good idea to start

by comparing the parts in your kit with the parts list below.

Be sure to take all applicable safety precautions dur-

ing the installation of the kit. The instructions listed in this

brochure and the illustrations all show the left, or driver’s

side of the vehicle. To install the right side assembly simply

follow the same procedures.

Your kit includes separate inﬂation valves and air lines

for each air helper spring. This will allow you to level your

vehicle from side to side as well as from front to back. If

you would rather have a single valve inﬂation system, your

dealer can supply the required “T” ﬁtting.

Important!

DO NOT COMPRESS SHOCK MORE THAN 1 INCH

PRIOR TO & DURING INSTALLATION!

For your safety and to prevent possible damage to your

vehicle, do not exceed the maximum load recommended

by the vehicle manufacturer (GVWR). Although your Air

Helper Springs are rated at a maximum inﬂation pressure

of 100 psi, this pressure may allow you to carry too great

a load on some vehicles. It is best to have your vehicle

weighed once it is completely loaded and compare that

weight to the maximum allowed. Check your vehicle owner’s

manual or data plate on driver’s side door for maximum

loads listed for your vehicle.

When inﬂating your Air Helper Springs, add air pressure

in small quantities, checking pressure frequently during

inﬂation. The air spring requires much less air volume than

a tire and, therefore, inﬂates much quicker.

PARTS LIST

AIR OVER SHOCKS 7210 2

UPPER BUSHINGS 9340 4

LOWER BUSHINGS 9405 4

LOWER BUSHING SLEEVES 9342 2

NYLOCK HEX NUTS 2

LARGE WASHERS 2

5/16” FLAT WASHERS 4

AIR LINE TUBIING 1

ELBOW FITTINGS 2

INFLATION VALVES 2

NYLON TIES 6

THERMAL SLEEVES 2

INSTALLATION INSTRUCTIONS

STEP 1— PREPARE VEHICLE

Raise the front of the vehicle and remove the wheels. Place jack stands rated for the

weight of the vehicle under the frame just reward of the front axle, lower the vehicle

onto the jack stands, and allow the front suspension to extend. See Figure “A”.

Remove the nut on the top of the factory-style shock. Next, remove the nut and

bolt that attaches the bottom of the shock to the lower portion of the suspension.

Now remove the factory-style shock from the vehicle. See Figures “B” & “C”.

STEP 2—PREASSEMBLE THE AIR OVER SHOCK

Install the lower bushings into the large hole on the bottom of the Air Over shock.

Insert one lower busing sleeve into the lower bushings. Place one of the upper bush-

ings, with the nipple pointing up, onto the threaded portion of the rod on top of the

shock. Install the elbow ﬁtting into the air inlet near the top of the shock. Tighten the

air ﬁtting enough to engage the orange thread sealant. Position the ﬁtting to point

in the anticipated location of the inﬂation valve.

FIGURE “A”

23-8354 06-11 NAD-35479-2

1 2 3 4

Résumé du contenu

Page 1 - Level-Rite

1003Level-RiteCongratulations— your new Air Helper Springs are quality products capable of improving the handling and comfort of your vehicle. As with

Page 2 - STEP 5— CHECK THE SYSTEM

STEP 3— INSTALLING THE AIR OVER SHOCKInsert the Air Over shock into the upper and lower shock mounts. Note: The air ﬁtting should point towards the re

Page 3 - FIGURE “F”

FIGURE “G”FIGURE “H”FIGURE “F”

Page 4 - REMOTE AIR COMMAND

For your convenience, Firestone offers a complete line of air accessories. Shown below are some of the more popular kits. Contact your Ride-Rite deale

Commentaires sur ces manuels

Pas de commentaire

Rite-ride 1003 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Rite-ride 1003. Rite-Ride 1003 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Rite-ride 1003