Rite-ride 2475 Manuel d'utilisateur télécharger pdf

2475

PARTS LIST

INSTALLATION I NSTRUCTIONS

Congratulations - your new Air Helper Springs are quality

products capable of improving the handling and comfort of

your vehicle. As with all products, proper installation is the

key to obtaining all of the benefits your kit is capable of

delivering. Please take a few minutes to read through the

instructions to identify the components and learn where and

how they are used. It is a good idea to start by comparing the

parts in your kit with the parts list below.

The heart of the air spring kit is, of course, the air helper

springs. Remember that the air helper springs must flex and

expand during operation, so be sure that there is enough

clearance to do so without rubbing against any other part of

the vehicle.

Be sure to take all applicable safety precautions during the

installation of the kit. The instructions listed in this brochure

and the illustrations all show the left, or driver’s side of the

vehicle. To install the right side assembly simply follow the

same procedures.

This kit includes inflation valves and air lines for each air

spring. This will allow you to compensate for unbalanced

loads. If you would rather have a single inflation valve

system to provide equal pressure to both air springs, your

dealer can supply the optional "T" fitting.

IMPORTANT!

For your safety and to prevent possible damage to

your vehicle, do not exceed the maximum load

recommended by the vehicle manufacturer (GVWR).

Although your Air Helper Springs are rated at a maximum

inflation pressure of 100 psi, this pressure may allow you

to carry too great a load on some vehicles. It is best to

have your vehicle weighed once it is completely loaded

and compare that weight to the maximum allowed. Check

your vehicle owner’s manual or data plate on driver side

door for maximum loads listed for your vehicle.

When inflating your Air Helper Springs, add air

pressure in small quantities, checking pressure frequently

during inflation. The air spring requires much less air

volume than a tire and, therefore, inflates much quicker.

WARNING:

Do not inflate this assembly when it is

unrestricted. The assembly must be restricted by

the suspension or other adequate structure. Do

not inflate beyond 100 psi. Improper use or over

inflation may cause property damage or severe

personal injury.

AIR SPRING 6873 2

UPPER BRACKET 5585 2

LOWER BRACKET 5586 2

BRACKET CLAMP 5103 2

3/8"-16 X 1-1/2" HEX BOLT 2

3/8"-16 FLANGE NUT 10

3/8"-16 X 3/4" FLANGE BOLT 2

3/8"-16 X 3 1/2" CARRIAGE BOLT 4

06-08 NAD-36720

3/8" FLAT WASHER 4

5/16" FLAT WASHER 4

18 ft. TUBING 0938 1

INFLATION VALVE 3032 2

ELBOW FITTING 3031 2

THERMAL SLEEVE 2

NYLON TIE WRAP 6

CAUTION TAG 2

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - WARNING:

2475PARTS LISTINSTALLATION I NSTRUCTIONSCongratulations - your new Air Helper Springs are qualityproducts capable of improving the handling and comfor

Page 2

6TROUBLE SHOOTING GUIDEAir spring will not inflateEnsure that the air line tubing is inserted into the air fittings as far as possible. The tubing s

Page 3

7FIRESTONE LIMITED LIFETIME AIR SPRING WARRANTYFirestone Industrial Products Company LLC (“Firestone”) warrants that its Ride Rite Air Spring Assembly

Page 4 - MAX PRESSURE (LOADED) 100 PSI

Page 5 - Trouble Shooting Guide

2475NOTE: The illustrations are ofthe left, or driver’s side ofthe vehicle. Follow the sameprocedures for the right side.3/8”-16FLANGEDLOCK NUT3/8”-16

Page 6

NOTE:Please read thorough this manual completely before installingthe air spring kit to your vehicle.STEP 1 - PREPARE THE VEHICLEThis kit can be insta

Page 7

STEP 6 - CHECK THE AIR SYSTEMOnce the inflation valves are installed, inflate the air helper springs to 70 psi and check the fittings for air leaks. U

Page 8 - ONLINE AUCTION PURCHASES

Operating Instructions and Trouble Shooting Guide21-1083 4-12 Thank you for purchasing Firestone air helper springs. You have purchased a quality prod

Page 9 - AIR SPRING TECHNICAL DATA

2SAFETY TIPSNever exceed the manufacturer’s recommended Gross Vehicle Weight Rating (GVWR)As with your vehicle’s tires, an air helper spring is a pneu

Page 10 - IMPORTANT

3the suspension system. As more air pressure is added to the air springs, they will support more weight. You will be able to compensate for a heavy lo

Page 11 - WARRANTY QUESTIONS

4INFLATING THE AIR SPRINGSWith the air helper springs installed on your vehicle and the vehicle sitting on a level surface, visually verify that the v

Page 12 - STEP #2:

5Description Style Ride Height“X”Min/Max AirPressureMax Load @100 psi(per pair)6868 Single Convoluted 160BY 5.0" - 6.0" 5 / 100 psi 3600 lbs

Commentaires sur ces manuels

Pas de commentaire

Rite-ride 2475 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Rite-ride 2475. Rite-Ride 2475 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Rite-ride 2475