Rite-ride 2169 Manuel d'utilisateur télécharger pdf

2169

NSTALLATION I NSTRUCTIONS

Congratulations - your new Sport-Rite Air Helper

Springs are quality products capable of improving the

handling and comfort of your vehicle. As with all

products, proper installation is the key to obtaining all of

the benefits your kit is capable of delivering. Please take

a few minutes to read through the instructions to identify

the components and learn where and how they are used.

It is a good idea to start by comparing the parts in your kit

with the parts list below.

The heart of the Sport-Rite kit is, of course, the air

helper springs. Remember that the air helper springs

must flex and expand during operation, so be sure that

there is enough clearance to do so without rubbing

against any other part of the vehicle.

Be sure to take all applicable safety precautions

during the installation of the kit. The instructions listed

in this brochure and the illustrations all show the right, or

passenger’s side of the vehicle. To install the left side

assembly simply follow the same procedures.

Your kit includes separate inflation valves and air lines

for each air helper spring. This will allow you to level your

vehicle from side to side as well as from front to back. If

you would rather have a single valve inflation system, your

dealer can supply the required "T" fitting.

IMPORTANT!

For your safety and to prevent possible damage to

your vehicle, do not exceed the maximum load recom-

mended by the vehicle manufacturer (GVWR). Al-

though your Sport-Rite Air Helper Springs are rated at a

maximum inflation pressure of 100 P.S.I., this pressure

may allow you to carry too great a load on some vehicles.

Check your vehicle owner’s manual for maximum loads

listed for your vehicle.

When inflating your Sport-Rite Air Helper Springs,

add air pressure in small quantities, checking pressure

frequently during inflation. The air spring requires

much less air volume than a tire and, therefore, inflates

much quicker.

21-8134 10-07 NCD-5855-2

WARNING:

Do not inflate this assembly when it is

unrestricted. The assembly must be restricted

by the suspension or other adequate structure.

Do not inflate beyond 100 P.S.I. Improper use

or over inflation may cause property damage or

severe personal injury.

PARTS LIST

AIR SPRINGS 9000 2

UPPER BRACKETS 5202 2

LOWER BRACKETS 5215 2

DISK 5204 2

BRACKET STRAPS 5086 2

AIR LINE TUBING 1

3/8"-16 X 1-1/2" HEX BOLTS 8

3/8"-16 FLANGE LOCK NUTS 12

3/8"-16 X 3/4" FLANGED HEX BOLTS 6

3/8" SPECIAL FLAT WASHERS 8

3/8"-16 X 3.5" CARRIAGE BOLTS 4

5/16" FLAT WASHERS 4

PUSH TO CONNECT

INFLATION VALVES 2

PUSH TO CONNECT

FITTINGS 2

NYLON TIES 6

THERMAL SLEEVE 2

CAUTION TAG 2

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - PARTS LIST

2169INSTALLATION I NSTRUCTIONSCongratulations - your new Sport-Rite Air HelperSprings are quality products capable of improving thehandling and comfor

Page 2

6TROUBLE SHOOTING GUIDEAir spring will not inflateEnsure that the air line tubing is inserted into the air fittings as far as possible. The tubing s

Page 3 - X = 7.25

7FIRESTONE LIMITED LIFETIME AIR SPRING WARRANTYFirestone Industrial Products Company LLC (“Firestone”) warrants that its Ride Rite Air Spring Assembly

Page 4 - MAX PRESSURE (LOADED) 100 PSI

Page 5 - Operating Instructions and

Page 6

NOTE LOWERBRACKET LOCATIONX = 7.25“X” “X”DRIVER’S SIDEFRONTFigure "B"Figure "D"AIR LINEPUSH-TO-CONNECTINFLATION VALVEFLAT WASHERH

Page 7

STEP 7 - INSTALL THE AIR LINE AND INFLATION VALVEUncoil the air tubing and cut it into two equal lengths. DO NOT FOLD OR KINK THE TUBING. Try to mak

Page 8 - ONLINE AUCTION PURCHASES

Operating Instructions and Trouble Shooting Guide21-1083 4-12 Thank you for purchasing Firestone air helper springs. You have purchased a quality prod

Page 9 - AIR SPRING TECHNICAL DATA

2SAFETY TIPSNever exceed the manufacturer’s recommended Gross Vehicle Weight Rating (GVWR)As with your vehicle’s tires, an air helper spring is a pneu

Page 10 - IMPORTANT

3the suspension system. As more air pressure is added to the air springs, they will support more weight. You will be able to compensate for a heavy lo

Page 11

4INFLATING THE AIR SPRINGSWith the air helper springs installed on your vehicle and the vehicle sitting on a level surface, visually verify that the v

Page 12 - Air Command™

5Description Style Ride Height“X”Min/Max AirPressureMax Load @100 psi(per pair)6868 Single Convoluted 160BY 5.0" - 6.0" 5 / 100 psi 3600 lbs

Commentaires sur ces manuels

Pas de commentaire

Rite-ride 2169 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Rite-ride 2169. Rite-Ride 2169 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Rite-ride 2169